BIXOLON SRP-350II Manuale Utente

User’s Manual SRP-350II Thermal Printer Rev. 1.01 http://www.bixolon.com

Rev. 1.01 - 10 -SRP-350II1-2-3 USB Interface USB Pin No. Signal Name Assignment (Color) Function Shell Shield Drain Wire Frame Ground 1 VBUS

Rev. 1.01 - 11 -SRP-350II1-4 Setting the Dip Switches 1-4-1 Serial Interface • DIP Switch 1 SW Function ON OFF Default 1-1 Auto Line Feed Enab

Rev. 1.01 - 12 -SRP-350II• Table 1 – Baud rate (bps) Selection Transmission Speed 1-6 1-7 1-8 Default 2400 ON OFF OFF 4800 ON OFF ON 9600 OFF ON

Rev. 1.01 - 13 -SRP-350II1-5 Installing or Replacing the Paper Roll ※ NOTE Be sure to use paper rolls that meet the specifications. Do not use paper

Rev. 1.01 - 14 -SRP-350II1-5-5 Be sure to note the correct direction that the paper comes off the roll. 1-5-6 Pull out a small amount of paper, as

Rev. 1.01 - 15 -SRP-350II1-6 Adjustments and Settings The SRP-350II is set up at the factory to be appropriate for almost all users. It does, howeve

Rev. 1.01 - 16 -SRP-350II1-8 Connecting the computer You need an appropriate interface cable. 1-8-1 Plug the cable connector securely into the prin

Rev. 1.01 - 17 -SRP-350II2. Self Test The self-test checks whether the printer has any problems. If the printer does not function properly, contact

Rev. 1.01 - 18 -SRP-350II3. Hexadecimal Dumping This feature allows experienced users to see exactly what data is coming to the printer. This can be

Rev. 1.01 - 19 -SRP-350II4. Specification Printing method Thermal line printing Dot density 180 dpi (7dots/mm) Printing width 72 mm Paper width

Rev. 1.01 - 2 - SRP-350II Safety Precautions In using the present appliance, please keep the following safety regulations in order to prevent any h

Rev. 1.01 - 20 -SRP-350II5. Appendix 5-1 Cleaning Printer Paper dust inside the printer may lower the print quality. In this case clean the printer

Rev. 1.01 - 3 - SRP-350II CAUTION Violating following instructions can cause slight wound or damage the appliance. Do not use the printer

Rev. 1.01 - 4 - SRP-350II Warning - U.S.A This equipment has been tested and found to comply with the limits for a Class A digital device pursuant

Rev. 1.01 - 5 - SRP-350II Introduction The SRP-350II Roll Printer are designed for use with electronic instruments such as system ECR, POS, banking

Rev. 1.01 - 6 - SRP-350II Table of Contents 1. Setting Up the Printer ...

Rev. 1.01 - 7 - SRP-350II1. Setting Up the Printer 1-1 Unpacking Your printer box should include these items. If any items are damaged or missing,

Rev. 1.01 - 8 - SRP-350II1-2 Connecting the Cables You can connect up the three cables to the printer. They all connect to the connector panel on th

Rev. 1.01 - 9 - SRP-350II1-2-2 Parallel Interface (IEEE1284) Pin No. Source Compatibility Mode Nibble Mode 1 Host nStrobe HostClk 2 Host / P